The circuit above is a circuit of drivers to control high voltage using the relay. Relay is controlled by an NPN transistor , its that works on 5V voltage and has diode in it, if the relay does not have s diode should be given with diode 1N4007 . Pin relay to move the switch connected to V+ 5V and other is connected from driver NPN transistor , the base od the transistor may have input such us from circuit of infrared to control the distance, or with some other input.After the transistor was input and the collector had output a voltage of the switch relay will work, and voltage that in switch relay ready to use. To cut off switch eliminates enough voltage input at the base transistor , the collector will not remove the voltage , and switch are automatically disconnected.
I’ve already shown how to drive an N-channel MOSFET (or even an IGBT) in both high-side and low-side configurations in a multitude of ways. I’ve also explained the principles of driving the MOSFETs in these configurations. The dedicated drivers I’ve shown so far are the TC427 and IR2110. Some people have requested me to write up on MOSFET drive using the very popular TLP250. And I’ll explain that here. The TLP250, like any driver, has an input stage, an output stage and a power supply connection. What’s special about the TLP250 is that the TLP250 is an optically isolated driver, meaning that the input and output are “optically isolated”. The isolation is optical – the input stage is an LED and the receiving output stage is light sensitive (think “photodetector”). Before delving any further, let’s look at the pin configuration and the truth table. Fig. 1 - TLP250 Pin Configuration Fig. 2 - TLP250 Truth Table Fig. 1 clearly shows the input LED side and the receiving photodetector as well...

Comments
Post a Comment