Skip to main content

Posts

Showing posts with the label one

Class one Headphone Amplifier

Class one Headphone Amplifier Circuit diagram. This circuit is derived from the Portable Headphone Amplifier featuring an NPN/PNP compound pair emitter follower output stage. An improved output driving capability is gained by making this a push-pull Class-A arrangement. Output power can reach 427mW RMS into a 32 Ohm load at a fixed standing current of 100mA. The single voltage gain stage allows the easy implementation of a shunt-feedback circuitry giving excellent frequency stability. Class one Headphone Amplifier Circuit diagram : Class-A Headphone Amplifier Circuit diagram The above mentioned shunt-feedback configuration also allows the easy addition of frequency dependent networks in order to obtain an useful, unobtrusive, switchable Tilt control (optional). When SW1 is set in the first position a gentle, shelving bass lift and treble cut is obtained. The central position of SW1 allows a flat frequency response, whereas the third position of this switch enables a shelving treble li...

Kenstar CTV – S2112C Schematic TDA12020H One Chip Micom

Used ICs: TDA12020H-(One Chip Micom) – 24C16 – TEA2025B – TDA7266 – STV9302 – TEA1520P  Circuit Diagram

The finish part one

Finishing a guitar is pretty tricky. I suppose if you just want to paint it, then that would be a lot easier, but I wanted to stain mine, then lacquer over the top. This is how I did that. Firstly, I had to construct some sort of holder for the guitar. I did this with an old broken wood plane I had lying around, which fitted the neck joint nicely. I then made a wooden handle for it and drilled a big hole down it so that I could mount it on a spindle. Badly as this photo turned out, you can see the stand holding the guitar up. It is sitting on a spindle poking out of the top of a big block of wood, held down by a vise. The theory was that I could freely rotate the guitar body this way, and even lift it off the spindle and hold it by the handle. The first thing I did was to add some water soluble stain. This is just wiped on with a cloth and immediately adds a lot of character to the wood. Here it is after a layer or two of the stain. You can add as many layers as you want. Each one will...

One transistor code lock

Description. This is of course the simplest electronic code lock circuit one can make. The circuit uses one transistor, a relay and few passive components. The simplicity does not have any influence on the performance and this circuit works really fine. The circuit is nothing but a simple transistor switch with a relay at its collector as load. Five switches (S0 to S4) arranged in series with the current limiting resistor R2 is connected across the base of the transistor and positive supply rail. Another five switches (S5 to S9) arranged in parallel is connected across the base of the transistor and ground. The transistor Q1 will be ON and relay will be activated only if all the switches S0 to S4 are ON and S5 to S9 are OFF. Arrange these switches in a shuffled manner on the panel and that it. The relay will be ON only if the switches S0 to S9 are either OFF or ON in the correct combination. The device to be controlled using the lock circuit can be connected through the relay terminal...