Skip to main content

Posts

Showing posts with the label PLC

Addressing of Siemens PLC S7 200

Addressing of Siemens PLC S7 200 Digital Input I0.0 to I0.11 Digital Output Q0.0 to Q0.7 Analog Input IW0 Analog Output QW0 Timers T32 to T63 For Timers : Time Delay = Time Base * Preset Time Done Bit : Tx Where X is address of Timer used. Counters C0 to C63 For Counter:   Preset is number of Counts. Counter Done Bit : Cx Where X is address of counter used. Integer VW0 to VW1022 Binary V0.0 to V1023.7 Programming Software : Microwin Driver For Programming: PPI Driver. Driver For SCADA Communication : S7200PPI DDE

PLC FAULT CHECK MAINTENANCE

Judge the Error through the Indicator at the Front Panel When error occurred for the DVP PLC, please check : POWER LED There is a “POWER” LED at the front of the MPU. When the MPU is powered On, the green LED light will be on. If the indicator is not on when the MPU is powered up and with the input power being normal, it is an indication that the PLC is out of order. Please have this machine replaced or have it repaired at a dealer near you. RUN LED Identify the status of the PLC. When the PLC is in operation, this light will be on, and users could thus useHPP or the ladder diagram to edit program and give commands to make the PLC “RUN” or “STOP”. ERROR LED 1. If illegitimate program is input to the MPU, or that the commands and devices of the program exceed the allowable range, the indicator will thus be blinking. In this case, the user should inquire about the errorcode from the special data register D1004 in the MPU and look it up in the Error Code Table. After the error is found ...

Mitsubishi PLC FX2N HMI E1000 Networking using BDTP Technology

Networking between E1000 terminals using BDTP Technology.          1.    Material Requirement The required material for the setup is as follows Sr. no. Material 1 PLC Type   : FX Series 2 CPU            :   FX2N 3 PLC S/W    : GX Developer Ver. 8.45X 4 HMI            : E1041,E1043 5 Other   2. Diagram   Network communication via BDTP is used to connect two or more E1000 -series operator terminals to one or two controllers or several operator terminals to two or more controllers, with retained performance. Figure 1 Networking between E –Terminals using BDTP Technology   Cables The required cables are as follows      Sr. no. Item Description 1 Medoc cable Prog. cable for FX PLC 2 Ethernet Cross Cable Comm. Cable for E-Terminal to E-Terminal & PLC*1 *1 To connect the E-Ter...