Improving Performance Bass Guitar

1. Replace strings: strings are the source of the sound of a bass. If bad strings, of course difficult to get a good sound. How good / expensive any bass, if strings are mendem ("dead") would sound so bad

2. Know your bass character of us, whether inclined treble, middle, or ngebass (low). From here our reference point. If soundnya not in accordance with our desires, try to correction with tone control / equalizer.

3. There are so many factors affecting the bass sounds, ranging from strings, pickups, body wood, neck & fingerboard.
Try to identify the character masing2, eg the influence of wood types, pickup types, etc..
From there we can determine which one should be modified.

Chain audio a bass sound as follows
Strings-> pickup-> Preamp / Tone Control-> Connection Cable-> Amplifier
Well, just select which one would aja in mod.

Actually the material (wood) body / neck / fingerboard also influence:

String-> Body/Neck/Fingerboard-> Pickup-> Preamp / Tone Control-> Connection Cable-> Amplifier (+ Speaker)

Only if you replace the body just wrote instead of bass.
So, if you can choose a distinguished bass wood is good, Ntar if you want to be upgraded more easily.
If wood is not good (Agathis), although the results are less than the maximum upgrade.

Comments

OP AMP INTEGRATOR CALCULATOR

Enter the Input Voltage,Vin: Volts Enter the Frequency, f: Hertz Enter the Input Resistance, Rin: Ohms Enter the Value of Capacitor, C: Farads Output Voltage, Vout: Volts OP AMP based Integrator Tutorial and Design

Block diagram of AM transmitter and receiver with explanation

Block diagram of AM transmitter and receiver with explanation AM Transmitter : Transmitters that transmit AM signals are known as AM transmitters. These transmitters are used in medium wave (MW) and short wave (SW) frequency bands for AM broadcast. The MW band has frequencies between 550 KHz and 1650 KHz, and the SW band has frequencies ranging from 3 MHz to 30 MHz. The two types of AM transmitters that are used based on their transmitting powers are: · High Level · Low Level High level transmitters use high level modulation, and low level transmitters use low level modulation. The choice between the two modulation schemes depends on the transmitting power of the AM transmitter. In broadcast transmitters, where the transmitting power may be of the order of kilowatts, high level modulation is employed. In low power transmitters, where only a few watts of transmitting power are required , low...

Using the TLP250 Isolated MOSFET Driver Explanation and Example Circuits

I’ve already shown how to drive an N-channel MOSFET (or even an IGBT) in both high-side and low-side configurations in a multitude of ways. I’ve also explained the principles of driving the MOSFETs in these configurations. The dedicated drivers I’ve shown so far are the TC427 and IR2110. Some people have requested me to write up on MOSFET drive using the very popular TLP250. And I’ll explain that here. The TLP250, like any driver, has an input stage, an output stage and a power supply connection. What’s special about the TLP250 is that the TLP250 is an optically isolated driver, meaning that the input and output are “optically isolated”. The isolation is optical – the input stage is an LED and the receiving output stage is light sensitive (think “photodetector”). Before delving any further, let’s look at the pin configuration and the truth table. Fig. 1 - TLP250 Pin Configuration Fig. 2 - TLP250 Truth Table Fig. 1 clearly shows the input LED side and the receiving photodetector as well...

Do More

Search This Blog