10W Audio Amplifier

Here is simple electronic circuit diagram project of 10W Audio Amplifier.With only an integrated as active element circuit this circuit is capable of providing up to 10W of power on a charge that can be between 2 and 8.

10W Audio Amplifier Circuit Diagram:

Obviously the integrated circuit, a TDA2003, should be placed with a suitable heat sink to prevent damage to its internal components above temperature in the capsule.

At maximum power circuit needs 2A to work correctly.

The 10W are obtained in the optimum working a load of 4 Ω. The entry must be at least 1 VPP to achieve this performance.

Power:

V max: simple 18V DC
I max: 2A

Parts List:
R1 100 kΩ
R2 47 Ω
R3 220 Ohm
2.2 R4 Oh
R5 1 h

SPK 4 Ohms

C1 2.2 µF
C2 470 µF
C3 47 nF
C4 100 nF
C5 1000 µF
C6 100 nF

IC1 TDA2003

Comments

OP AMP INTEGRATOR CALCULATOR

Enter the Input Voltage,Vin: Volts Enter the Frequency, f: Hertz Enter the Input Resistance, Rin: Ohms Enter the Value of Capacitor, C: Farads Output Voltage, Vout: Volts OP AMP based Integrator Tutorial and Design

Using the TLP250 Isolated MOSFET Driver Explanation and Example Circuits

I’ve already shown how to drive an N-channel MOSFET (or even an IGBT) in both high-side and low-side configurations in a multitude of ways. I’ve also explained the principles of driving the MOSFETs in these configurations. The dedicated drivers I’ve shown so far are the TC427 and IR2110. Some people have requested me to write up on MOSFET drive using the very popular TLP250. And I’ll explain that here. The TLP250, like any driver, has an input stage, an output stage and a power supply connection. What’s special about the TLP250 is that the TLP250 is an optically isolated driver, meaning that the input and output are “optically isolated”. The isolation is optical – the input stage is an LED and the receiving output stage is light sensitive (think “photodetector”). Before delving any further, let’s look at the pin configuration and the truth table. Fig. 1 - TLP250 Pin Configuration Fig. 2 - TLP250 Truth Table Fig. 1 clearly shows the input LED side and the receiving photodetector as well...

Audio signal processing IC for 1 5 V headphone stereo

General Description: The AN7500FHQ is a single chip IC optimum for a 1.5 V headphone stereo system including pre-amp., power amp. and Dolby B type noise reduction circuit. Current consumption in a Dolby circuit off mode has been drastically reduced and an operating supply voltage has also been lowered to 0.98 V. Much fewer external components have been realized due to an integration of audio signal processing system into a single chip circuitry in a small outline package and space saving mounting of a set. Circuit Diagram Audio signal processing IC for 1.5 V headphone stereo

Do More

Search This Blog